Bright Motion Sensor Solar Wall Light Aluminium Alloy Shell 4 Modes

Product Features:

- Outdoor Bright Motion Sensor Solar Wall Light Aluminium Alloy Shell 4 Modes is an energy-efficient and grid-independent lighting products powered by Solar Energy.

- Improved Solar Panel with high Energy Conversion rate to shorten the charging time.

- Bright performance delivered by SMD 2835 LED Chip in 48LED or 60LED combination with wide lighting angle [900lm or 1100lm]. Available in White or Warm White lighting colour. 

- Powerful LiFePO4 battery with stretched performance life provides longer lighting [3.2V, 4500mAh or 9000mAh].  

- FOUR Lighting Modes including: 

• Constant full-brightness light with automatic light control sensor;
• Constant energy-saving DIM light with Motion Sensor and automatic light control;
• Motion Sensor only with automatic light control.
• Emergency Lighting mode for 30min.

- Advanced security features including Microwave Radar Motion Sensor with wide 180° angle and 5-10m range. 

- Fully automated operation process with Special built-in Light-control System for day/ night mode detection that turns the light on at night and off during the day.

- Durable Aluminium Alloy body shell. Waterproof and Heatproof design: enhanced IP65 water and weather resistance.

- Completely safe, easy to install, setup and operate. Lightweight. 

- No maintenance or electricity cost. User-friendly design, no wiring or any professional installation required. 

Operational Modes: 

Mode1: the light will turn on automatically at night at full-brightness and turn off during the day or at a bright lighting environment.

Mode 2: the light will automatically turn on in energy-saving DIM low brightness light at night and stay like this until the motion is detected within 5-10m range. Then the light will turn on full-brightness for 15 seconds and if the motion stopped will go back into the DIM light.

Mode 3: the light will remain off until it detects the motion. Then the light will turn on full-brightness for 15 seconds and after the motion is stopped, the light will turn off.

Mode 4: an emergency. The light will remain for 30 min on constant full brightness. 

Application: 

The Outdoor Bright Motion Sensor Solar Wall Light Aluminium Alloy Shell 4 Modes delivers reliable lighting and is ideal for maintaining casual, emergency or security lighting around the house, garage, driveway, garden, patios, side and backyard, aisles, stairs, entryway, path, fence etc. 

- Security lighting for any kind of premises and real estate.

Package Included:

1 x Solar Powered Light;

1 x Installation Kit.

Important Information

1. As the power of the Solar Panel is depended on the sunlight, the LED lighting time and brightness is affected by weather, seasons, places, etc.

2. Make sure that the Solar Panel is not sheltered from the sun that would prevent the battery from proper charging.

3. The battery can only be charged when the switch is turned ON.

General maintenance tips about how to improve the Solar Panel’s life and efficiency of Solar Powered light:

- Solar Panel of bright motion sensor solar wall light aluminium alloy shell should be installed in a well-lit area where it can receive maximum straight sunlight during daytime. Any cover that shades the Solar Panel will affect its ability to absorb sunlight and as a result, decrease a device’s performance.

- Clean the surface of the Solar Panel with a soft, slightly moistened cloth with soap and water or a dry brush only. Do not use any corrosive cleaning liquids or chemicals since this may damage the housing surface or impair future operation.

- Keep the Solar Panel free of dirt, debris and snow otherwise the battery will not charge properly or might also shorten battery life or cause a malfunction.

- It is recommended to place the product under the sun for recharging even it is not being used to prevent from a dead battery and maximize its life. 

- In a case when the product is not being used for a long time, charge it for at least 10 hours by the sun before use. 

- Please, keep the product away from the fire to prevent explosion hazard.